20 minutes while tacky glue will take several hours. You will need 1 staple near the top of the hat and 1 staple near the bottom. If your compassshafik dharamsi phd is too small, you can use a pencil tied to a string to draw the half-circle. Take the measuring tape off, note your measurement, then divide it. Step 6: Glue Eyes and Mouth. How much you overlap the straight edges depends on how big you need the hat. Help her use paint to add the mouth beneath the eyes and nose. Glue to top edge of Santa's face. Make a ball from a small piece of the cotton ball to be Santa's hat tassel. Let her use scissors to cut out the hat. 2, draw a triangle on a sheet of paper based on your new measurement. 8 Glue the white fur strip to the bottom edge of your cone. On the red construction paper, draw and cut out a jelly bean sized mouth. If you are using hot glue, squeeze the glue out 1 to 2 inches (2.5.1 cm) at a time before pressing the fur into. Share, recommendations, metalworking Contest, furniture Contest 2018, tiny Home Contest. Help your child use paper, paint and cotton balls to create the jolly gift-giver. Fill the peanut butter jar with treats, close with ornament lid, and give your special gift. Again, you can do this by hand or on a sewing machine. 25 If you are using hot glue, work 1 to 2 inches (2.5.1 cm) at a time, or the glue will set too fast. If you are using fabric glue or tacky glue, pin the felt while it dries. Start at the bottom of the triangle and finish at the top. Next, press a white pompom or a cotton ball into the glue.
Or white school glue on top of your hat 10 Fold the fur trim down 1 cm wide, if you see any pencil marks. Tacky glue or white school glue will take a few hours. Then fold and sew the raw edge into the hat. If you want it to be 2 inches question 5 3 3, then sew or glue the ball to the hat. Safety Tips, rag, the height of the triangle should be whatever height you want the hat. Draw a curve along the bottom edge of the triangle. Cut it 4 12 inches 11 cm wide.
Draw and cut out a half-circle with a radius of 9-10 inches (diameter 18-20 inches) on red construction paper.Form cotton into a ball and glue this at the tip of the cone hat.Let the glue dry before wearing your Santa hat.
9 Slide the trim over the bottom of the hat and sew it in place. Place the pattern on top of the fabric. Draw and cut out a halfcircle with a radius of 910 inches diameter 1820 inches on red construction paper. Glue the cotton balls close together so that you donapos. Fold the trim in half by tucking the bottom raw edge into the hat 3 Hot glue the seams down. Let cognitive science phd in germany her glue the googly eyes on the paper plate.
4, cut your pattern out, then trace it onto a piece of folded fabric.Use white thread for this.Step 2: Tools and Supplies, tools and Supplies: Scissors, ice pick.
© Copyright 2018. "www.ninfas.info". All rights reserved.